DT-OP

Digital Tacho, 8 Shift LEDs, and Digital Oil Pressure Gauge with Low Oil Pressure Alarm

£79.00

FEATURES

* 8 LED Bar Graph Display for RPM (fully programmable for any RPM band)

* Digital Oil Pressure Readout

* Programmable Under Pressure Alarm

* Price includes Wiring Loom

* Adjustable LED Brightness

* Suitable for most 1,2,4,5,6 & 8 Cylinder Four Stroke Engines

* Compact Size - 100mm wide x 65 mm tall x 23 mm deep

* 2 Year Parts and Labour Warranty

HOW IT WORKS

The DT-OP combines a Digital Tachometer, a series of 8 RPM Shift LEDs and Oil Pressure Gauge in one neat display. Powered by the 12 volts from the car or bike, it will function on most four stroke 1,2,4,5,6 or 8 cylinder engines.

The tacho is extremely accurate, having a resolution of approximatly 5 RPM at 7000 RPM for a four cylinder engine.The maximum RPM can be recalled and is retained in memory after powerdown. To make the display easier to read in normal operation, the RPM is displayed to the nearest 50 RPM. When the maximum RPM is recalled, it is displayed to the full accuracy.

The 8 LED's can be programmed to start and stop at any RPM enabling them to function over a very narrow RPM band. The LED's are programmed from the display allowing very precise setting of the RPM at which the LED's are turned on.

When an Oil pressure Sensor is connected, Oil Pressure between 5 PSI to 150 PSI can be displayed. A programmable under pressure alarm is incorporated. When low oil pressure is detected the LCD flahes 'OIL' and the LEDs also flash. This can be cancelled by pressing the side button or waiting 5 seconds. By having a fast response the driver is made aware of any potential problem immediately, and could minimise any damage to the engine. The alarm is not tested below 3000 RPM allowing a higher oil pressure setting to be programmed, without the alarm being triggered at tick-over.

For drivers who prefer to use a mechanical oil pressure gauge, an oil pressure switch can be used instead of a pressure sensor. The alarm is triggered when the switch operates and the RPM is above 3000.

The DT-OP is supplied with the wiring loom but not the oil pressure sensor/switch. Full setting up instructions are included and the unit is simple to install and programme.

OIL PRESSURE SENSOR

The oil pressure sensor is offered as an option as some users will wish to
use a pressure switch instead.
Note that only the recommended sensor should be used.
The price of this sensor is £15.00.